VCS VIP 10 Uživatelská příručka stáhnout pdf (Strana 59)

Chapter 6 Configuring the Sender

VIP 10 59

Ethernet link type:

If the VIP is connected to the network via a switch, both devices must be set for

the same type of network connection. If necessary, ask your network

administrator about the switch setting.

The value can be set to 10 or 100 MBit/s and full or half-duplex mode (FD or HD)

or to Auto for an autosensing network connection.

Warning!

Errors such as picture interference can occur if the network is not suitable

for transmission of the maximum data rate generated by the VIP.

Dynamic DNS server IP address:

When operating a unit over the Internet, an address pool with dynamic addresses

is used for greater efficiency. This means that the unit is assigned an IP address

each time a connection is made and this address varies. In this case, access is

easier if the unit is listed on a DNS server. It will contact the server at regular

intervals and register its unit name and IP address. To connect to the VIP via the

Internet, it is enough to enter the unit name and the URL of the DNS server. The

server returns the current Internet IP address for the connection.

You can use the DNS server of VCS videotec.info as DNS server. The

associated IP address is 195.145.107.78. The VIP contacts this server

automatically if the desired refresh interval is entered for the next parameter. If

the unit name is MyVIP for example, the URL MyVIP.videotec.info can be

entered in the browser to make a connection.

Dynamic DNS contact interval:

Enter the desired update interval in seconds.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 121 122

Žádné komentáře

VCS VIP 10 Uživatelská příručka Strana 59